Hello! I'm a musician and a sound engineer and I've jumped to Manjaro from Debian because of Pipewire (it doesn't work properly on Debian-based systems but it does on Manjaro). I'm tired with the lots of XRuns on the Jack, so one of my tasks is  to use two (and sometimes three) Behringer XR18 mixers as the audio capture devices or stage boxes. I connect them to a computer with USB and make a multicast stream with Zita-NJbridge (36 or 54 channels) and use 3 other computers with Ardour as mixer consoles - one as FOH mixer, one as monitor mixer and one as mixer for streams. It's impossible with Jack because of XRuns but Pipewire works greatly. <div>In the release a month ago there wasn't the Pipewire with all things (pipewire-pulse, pipewire-jack, etc.) so what have I done:</div><div>1. Remove Pulseaudio, </div><div>2. Reboot, </div><div>3. Install Pipewire with all its things including pipewire-jack-dropin from AUR, </div><div>4. Reboot again. </div><div>As the result, pipewire works properly. </div><div><br /></div><div>I've lost the month-ago release and I've downloaded the actual one which contains pre-installed both Pulseaudio and Pipewire (pipewire without the Alsa and Jack modules). I've done the same and Pipewire works properly with my XR18's and other USB soundcards but it doesn't work with the built-in soundcard which I need, for example, for the talkback. </div><div>Could you help me, where I have mistakes? </div><div><br /></div><div>Thank you! </div><div>Fedor a.k.a. Billy the Hippo,</div><div>Moscow, Russia. </div>